8 July 2017 – Suspension Set up – Introduction
The next job for us was to look at setting up the suspension including, the Ride height, Toe and Camber. This was a job that we had been putting off as we [...]
8 July 2017 – Suspension Set Up – Ride height set up
Before we started doing any setting up it is important to first check the tyre pressures are all consistent. We set this to 30psi all round. We also placed the 4 wheels [...]
8 July 2017 – Camber Set Up
Camber After setting the toe front and rear we looked at setting the camber. To measure this we used a bar with 2 bolts sticking out, each bolt measured the same distance off [...]
8 July 2017 – Toe Set up
Toe Next was to set up the wheel toe, Richard had some poles with grooves cut into them. These were based on the ‘Smart String 4 Wheel Toe Alignment System’ that he had [...]